Doug - aka "Dogfish"
Registered
I recently aqquired a Sherwood tank with a 1/2" thread neck. What do I need to get a valve for a yoke set up?
Steel 100 tank
- Thread starter Doug - aka "Dogfish"
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
- Messages
- 20,562
- Reaction score
- 14,954
- # of dives
- I'm a Fish!
you sure it's a half inch neck not a 7/8 neck? how old is it? I could be wrong, but i think the 1/2" were all yoke. You probably have a 7/8 neck and you can't get those in yoke valves per DOT regulations.
If it's the PST tank with the 300 bar valve you might be stuck with a DIN valve.
Bob DBF
Contributor
Or looking for a trade.
Bob
--------------------------------
There is no problem that can't be solved with a liberal application of sex, tequila, money, duct tape, or high explosives, not necessarily in that order.
Sherwood SCUBA rep.
Contributor
Sherwood suggests taking the tank to an authorized dealer to have the tank identified, tested and inspected. It is vital that the tank have the correct valve with the correct working pressure burst disc and that the valve be properly installed, lubricated and reinspected. We only sell 3/4" valves currently. We wish you the best of luck in getting the tank situated the way you want it.
Safe diving,
Team Sherwood
Safe diving,
Team Sherwood
Similar threads
