KD8NPB
Contributor
Scubapro Drysuit
Vulcanized rubber construction (hard wearing, long lasting, easy to repair)
Cuff dump (not a traditional shoulder dump)
Front Zip with heavy duty BDM zipper (same as Viking commercial suits)
This suit has a latex hood on it. It has a few blobs of Aquaseal inside. I inflated the suit and sprayed it down with soap solution. I did not see any leaks, so it seems like the Aquaseal did its job.
Suit is approximately an XL. I could not find any literature on this suit, so I had to hand measure the sizes. These are all approximates:
Height : 5'10" - 5'11" MAX
Boots : US 12
Inseam : 35"
Neck-to-Cuff : 31"
Shoulder-to-crotch : 38"
Waist & Chest : About 43"
BONUS:
If you purchase this suit, as an option, I will install a new Viking neckseal, and two Viking Pro Cuff seals at parts cost only (no labor) utilizing the proper Viking rubber suit adhesive. I will not install another latex hood. Viking produces some of the best latex seals on the market. Hit them with a spritz of McNett's UV Tech once or twice a year, and you'll get years of use out of the seals.
$590 shipped as-is
+
New Seals ($30 cuff + $30 cuff + $35 neck + $30 adhesive, hardener, solvent)
[Special : $100]
$690 shipped with fresh, uncut seals!
I'll post some pictures soon.
Vulcanized rubber construction (hard wearing, long lasting, easy to repair)
Cuff dump (not a traditional shoulder dump)
Front Zip with heavy duty BDM zipper (same as Viking commercial suits)
This suit has a latex hood on it. It has a few blobs of Aquaseal inside. I inflated the suit and sprayed it down with soap solution. I did not see any leaks, so it seems like the Aquaseal did its job.
Suit is approximately an XL. I could not find any literature on this suit, so I had to hand measure the sizes. These are all approximates:
Height : 5'10" - 5'11" MAX
Boots : US 12
Inseam : 35"
Neck-to-Cuff : 31"
Shoulder-to-crotch : 38"
Waist & Chest : About 43"
BONUS:
If you purchase this suit, as an option, I will install a new Viking neckseal, and two Viking Pro Cuff seals at parts cost only (no labor) utilizing the proper Viking rubber suit adhesive. I will not install another latex hood. Viking produces some of the best latex seals on the market. Hit them with a spritz of McNett's UV Tech once or twice a year, and you'll get years of use out of the seals.
$590 shipped as-is
+
New Seals ($30 cuff + $30 cuff + $35 neck + $30 adhesive, hardener, solvent)
[Special : $100]
$690 shipped with fresh, uncut seals!
I'll post some pictures soon.