mk25/s600 and Atomic SS1 octo

29South · Sep 20, 2006

hi,
I am planning on getting a scubapro mk25/S600 from my LDS and the Atomic SS1 from a not too LDS... This will likely be on an Aeris BC

I have seen comments relating to 1st stage air pressure requirements of atomic SS1... are their compatability issues i should be aware of?

Packhorse · Sep 21, 2006

I would assume that the IP of a MK20 would be the same as a MK25. I had slight free flow at the surface with my SS1 and MK20. But then the MK25 is externaly adjustable AFAIK so you could quite easily tune the IP lower yourself.

Jarrett · Sep 21, 2006

Why not just get an Atomic first stage as well? B2 or Z2? They are built to work with the SS1 and I think the Atomic is a better reg anyway.

29South · Sep 21, 2006

the mk25/s600 is from my lds which has offered (and given) excellent support and service. Unfortunately they doesnt do atomic..

I am attracted to the SS1 cos of the low profile and the ability to swap across BCs with the quick disconnect. The atomic dealer is 75 miles away but I was justifying the ss1 based upon a 2yr service requirement.

redacted · Sep 21, 2006

Service may be a PITA but the combo should work fine if that is what you want.

Packhorse · Sep 22, 2006

Jarrett:
Why not just get an Atomic first stage as well? B2 or Z2? They are built to work with the SS1 and I think the Atomic is a better reg anyway.

Really? why is that?

Jason Ooi · Sep 22, 2006

Go for Mk25/S600 never regret good performance regs

mk25/s600 and Atomic SS1 octo

Please register or login

29South

Guest

Packhorse

Contributor

Jarrett

Contributor

29South

Guest

redacted

Guest

Packhorse

Contributor

Jason Ooi

Contributor

Similar threads