After owning an Aeris Atmos 2 computer for several years I recently purchased an Aeris AI QD Navcon computer. I am concerned that when you disconnect the computer from the pressure hose these small orifices may become obstructed, especially on the computer orifice.
Does Aeris make a plug(s) that would simulate that the computer is connected, and thus eliminating the posibility these orifices would become clogged?
New in the box the regulator end of the pressure hose was capped. The use may be two fold protecting the threads and preventing any debris from entering the hose. However. the end user apparently must use a makeshift means to prevent a similar problem.
Any suggestions? Thanks!
Does Aeris make a plug(s) that would simulate that the computer is connected, and thus eliminating the posibility these orifices would become clogged?
New in the box the regulator end of the pressure hose was capped. The use may be two fold protecting the threads and preventing any debris from entering the hose. However. the end user apparently must use a makeshift means to prevent a similar problem.
Any suggestions? Thanks!