Putting together another Razor style harness and I thought that I'll pair this one off with the Stealth BC. Have downloaded the manual and looked it over a few times. What I saw was two loops on each side where they had bungee cords and one loop at the lowest point. Is that all or are there any slots like on the UTD Z-trims for the back webbing to go through?
The reason I'm asking if because I haven't ordered the BC yet but I'd really like to get this harness PERFECT and have been adjusting every D-ring with OCD madness so it's going to be a bit of a pain if the BC requires the harness to be dismantled for part of the webbing to be slotted in.
The reason I'm asking if because I haven't ordered the BC yet but I'd really like to get this harness PERFECT and have been adjusting every D-ring with OCD madness so it's going to be a bit of a pain if the BC requires the harness to be dismantled for part of the webbing to be slotted in.