skimon
Registered
I've been diving two years and try to clean my gear well after each dive by rinsing and soaking in fresh water since I dive almost exclusively in salt water. However, over the past 1 1/2 dives, the inflator button on my BCD low power inflator got stuck so that it slowly leaked air into the BCD which messed up my buoyancy and caused me to dump air every minute or so. (I at first attributed it to poor technique on my part, but then figured out what was happening and replicated the problem on the surface after the last dive.)
So, the question is: How can you flush fresh water through the inflator button on the BCD to keep salt and gunk from possible causing this problem.
Thanks.
So, the question is: How can you flush fresh water through the inflator button on the BCD to keep salt and gunk from possible causing this problem.
Thanks.