kiwi_diver
Registered
Does anyone know the correct assembly sequence for the 13 spring washers that make up the final safety valve on an '80's unit? This is the saftey valve that sits on top of the triplex filter housing. It's got a grey anodised aluminium cover that has "Bauer 225 BAR 3200 PSI" written on it. Under the cover is a threaded spindle with a locknut. The spindle goes down through the centre of 13 spring washers and acts on a ball which is the actual valve. Of course, we've had it apart and can't remember how the washers were packed in. Pretty sure they oppose each other in curvature to form a spring but if we set all 13 in alternating curvature, the group is too long to fit back in!
Help!
Thanks, Ray.
Help!
Thanks, Ray.