SubAquatix
Contributor
First off, should have typed that it was a Nitrogen Booster, then cleaned for O2 use.
I was able to pick up a 5G-TS-30/75 several years ago and have used it without issue. Last month, it finally tired an needed a full rework and I decided to have it done as a factory rework. Again, no issue. However, when I told them I had been using it for over 6 years for O2 use, and had it plumbed in for pure O2 at all times, they became a little sketchy, saying that the unit ran at 75:1, to rich for O2.
I run it very slowly, never letting the out put side exceed 100 degrees Fahrenheit. Typically, it can take a 1000 psi supply bottle and boost to 3000 in a 40ft3 bottle in about 5 minutes, running it in that manner.
Any thoughts on whether or not this is a real danger??
I was able to pick up a 5G-TS-30/75 several years ago and have used it without issue. Last month, it finally tired an needed a full rework and I decided to have it done as a factory rework. Again, no issue. However, when I told them I had been using it for over 6 years for O2 use, and had it plumbed in for pure O2 at all times, they became a little sketchy, saying that the unit ran at 75:1, to rich for O2.
I run it very slowly, never letting the out put side exceed 100 degrees Fahrenheit. Typically, it can take a 1000 psi supply bottle and boost to 3000 in a 40ft3 bottle in about 5 minutes, running it in that manner.
Any thoughts on whether or not this is a real danger??