geko21
Registered
I am playing with a new Bauer Vertecon 13 compressor and although most of the things are clear there are still a few points I can not figure out, and the manual is not very helpful.
The unit is set for 6000psi. However I will be filling to only 3200psi and will not be using banks. It is a basic compressor-4way Maniford setup. I can set the unit to shut down at 3200 through the electronic control unit but this would mean that it will stop the motor every time the four current tanks are filled and it will start again with the next set of tanks. I want to avoid the constant stop/start cycles.
What I need to do is set a valve to blow at 3200psi so that we can change tanks without the compressor shutting down - and basically eliminating the possibility of the unit ever reaching near 6000, and thus also avoiding possible tank blow up. How can I do that? I am aware that I may be missing something very basic. Any advice will be highly appreciated.
The unit is set for 6000psi. However I will be filling to only 3200psi and will not be using banks. It is a basic compressor-4way Maniford setup. I can set the unit to shut down at 3200 through the electronic control unit but this would mean that it will stop the motor every time the four current tanks are filled and it will start again with the next set of tanks. I want to avoid the constant stop/start cycles.
What I need to do is set a valve to blow at 3200psi so that we can change tanks without the compressor shutting down - and basically eliminating the possibility of the unit ever reaching near 6000, and thus also avoiding possible tank blow up. How can I do that? I am aware that I may be missing something very basic. Any advice will be highly appreciated.