dtdiver
Contributor
i have an older large scubapro brass spg that i got about 6 dives ago from my lds.
i replaced the o-rings when i got it.
it developed a small leak and when i removed the pin, the interior o-ring had "crud" on it.
it looked like some plain dirt and some blueish stuff- probably corrosion. i carefully cleaned the opening as far in as i could.
my question is how does one clean an spg without driving the crud into the bourdon tube?
thanks
dt
i replaced the o-rings when i got it.
it developed a small leak and when i removed the pin, the interior o-ring had "crud" on it.
it looked like some plain dirt and some blueish stuff- probably corrosion. i carefully cleaned the opening as far in as i could.
my question is how does one clean an spg without driving the crud into the bourdon tube?
thanks
dt