searching out some options to make some adapters. Anybody know the thread specification for O2 cells?
thread size for oxygen sensor cells?
- Thread starter rhwestfall
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
Camerone
Contributor
M16 x 1.0. Not too hard to find from metalworking suppliers. The more common M16 threads are generally either 2.0 or 1.5 (coarse and fine) so you may need to poke around a bit. I think I got my tap from Enco or MSC Direct...
<edit>Enco has them Model #891-4979 for just under $20. If I was going to tap soft plastic and it was a one off, I might just single-point thread it if I didn't already have one... </edit>
<edit>Enco has them Model #891-4979 for just under $20. If I was going to tap soft plastic and it was a one off, I might just single-point thread it if I didn't already have one... </edit>
OP
Thanks! Actually, I am seeking fittings to attach the cell to (your information is quite useful).
Similar threads
