It came to my attention that the rubber circle on my BC's OPV has gone missing. I acquired a replacement OPV, spring, hard plastic plunger, and soft rubber disk. The replacement part, rubber disk, does not press fit onto the plunger and readily falls out. On my single tank rig the OPV rubber disk is press fit into the plunger and does not come out when turned disk down. Should I use adhesive to stick the rubber disk into the plastic plunger? If so, any suggestion? Or should I get another part from a different vendor that is press fit?
Thanks!
---------- Post added April 21st, 2014 at 09:13 PM ----------
Learned proper terminology. The seat falls out of the seat retainer. Should it be glued in or press fit?
Thanks!
---------- Post added April 21st, 2014 at 09:13 PM ----------
Learned proper terminology. The seat falls out of the seat retainer. Should it be glued in or press fit?