Bri-Diver
Registered
I recently purchased 2 batteries from B&H for my Sea & Sea 2G. After charging the batteries I put them both in the camera and the camera will not power up. I tested both batteries and get 4.1V and I also confirmed the camera will power up using 2 AAA batteries. I don't have the original battery anymore because it did not last very long at all and using AAA batteries for more than a dozen shots with the flash is almost impossible.
I have looked at other sites and everyone seems to be selling the same 3.7V 1250mAh that can be used in both the 1G and 2G. Looking at the 2G it says that the requirements are 3.8V @ 1.9W.
B&H - Battery
Has anyone else experienced this, do I have the correct battery? I am putting the battery in correctly according to the manual (+/- points towards the lens side and up into the camera pointing towards the power button).
Thanks for any assistance.
I have looked at other sites and everyone seems to be selling the same 3.7V 1250mAh that can be used in both the 1G and 2G. Looking at the 2G it says that the requirements are 3.8V @ 1.9W.
B&H - Battery
Has anyone else experienced this, do I have the correct battery? I am putting the battery in correctly according to the manual (+/- points towards the lens side and up into the camera pointing towards the power button).
Thanks for any assistance.