Welcome to ScubaBoard, an online scuba diving forum community where you can join over 205,000 divers diving from around the world. If the topic is related to scuba diving, this is the place to find divers talking about it. To gain full access to ScubaBoard (and make this large box go away) you must register for a free account. As a registered member you will be able to:
Participate in over 500 dive topic forums and browse from over 5,500,000 posts.
Communicate privately with other divers from around the world.
Post your own photos or view from well over 100,000 user submitted images.
Gain access to our free classifieds marketplace to buy, sell and trade gear, travel and services.
Use the calendar to organize your events and enroll in other members' events.
Find a dive buddy or communicate directly with scuba equipment manufacturers.
All this and much more is available to you absolutely free when you register for an account, so sign up today!
NEW for 2014 Access SBlogbook for members. It allows you to directly upload data from your dive computer, validate your logs digitally, link your dives to photos, videos, dive centers (9,000 on file), fishes (14,000 on file) and much more.
If you have any problems with the registration process or your account login, please contact the ScubaBoard Support Team.
The shortest rope light I could find is six feet long. Any idea what one has to do to shorten to two feet :06:
With the light OFF inspect the internal bulb wiring closely using a backlight source. Most have several bulbs wired in series off the main power leads so you can't cut just anywhere and have it still work. The one I made several inspection lights from was 20V with 18 bulbs in series, then repeat. The light can be cut at any of the spaces between the series sets. I got about 6 inspection lights out of one rope light string. Cut at the gaps, then splice on a 120V plug and cord (spare computer power cords seem to work fine and are both ubiquitous and free.) Solder the connectons and slide heat shrink over each one, then overpot with a second heat shrink and some epoxy filler.
For a portable 12V light a couple of the low voltage "garden light" bulbs soldered onto a old speaker wire with alligator clips attached makes a truck or boat friendly inspection light small enoug to fit into 3/4"-14 tank necks.
I used to use any old flashlight bulb that matched the voltage of whatever little transformer I had laying around. For some reason the power supplies from radios, calculators, etc seem to multiply & exceed the amount of said appliances.
Some stiff wire, solder, & heat shrink make a light that can be manipulated right next to any questionable areas. I always preferred a single point light source because it could get maneuvered around to accent the relief/profile of any suspect areas, the contrast makes them stand out better.
I used a 50W bulb from my old halogen cave light and just hook it up to the old SLAs I used for the light and the entire cylinder is painfully bright inside! It works very, very well. I'll find out the bulb designation tonight.
<== Mighty Murphy, the wonder Bouv!