Naboodiver
Contributor
Zak,
Can you please pass on the bugs in DiverOrganizer to developer.. Thanks much!
Naboo
Bugs:
Under the Database drop down:
- The Weight and Height on the Diver input height of 5.6 (5'6") converts to 7 ft on save
The weight stores ok (ex. 180 lbs.) but shows up on the diver tab as 286 lbs. ???.
- May I suggest that the height should be split into two fields one for feet and one for inches, displayed together to give height or enter total inches in height and convert to ft and inches.
Under the Dive Site after selection a dive:
--------------------------------------------
On the Dive Info Tab:
- The firmware version is not displaying
- Visibility only allows meters in drop down. - This needs to allow ranges in Feet.
On the Setting Tab:
- The Depth and Temperature Units - no data displayed and is only in meters and Celsius units but the computer is set to ft. and Fahrenheit.
On the Tank Tab:
The Operating Tank Pressure does on save after input
--------------
Under the Dive Chart Tab
When you trace the cursor over the lines on the graph
- the correct time is not displayed - Every dive starts at 12:00 AM.
- the bar graph - print units and graph title is too small to read - What is this suppose to tell me?
________Note: You may or may not realize__________
I did not realize to change (right side panels) no deco time, depth and dive time and temp required clicking on the line.. This may have been obvious to everyone else.
Can you please pass on the bugs in DiverOrganizer to developer.. Thanks much!
Naboo
Bugs:
Under the Database drop down:
- The Weight and Height on the Diver input height of 5.6 (5'6") converts to 7 ft on save
The weight stores ok (ex. 180 lbs.) but shows up on the diver tab as 286 lbs. ???.
- May I suggest that the height should be split into two fields one for feet and one for inches, displayed together to give height or enter total inches in height and convert to ft and inches.
Under the Dive Site after selection a dive:
--------------------------------------------
On the Dive Info Tab:
- The firmware version is not displaying
- Visibility only allows meters in drop down. - This needs to allow ranges in Feet.
On the Setting Tab:
- The Depth and Temperature Units - no data displayed and is only in meters and Celsius units but the computer is set to ft. and Fahrenheit.
On the Tank Tab:
The Operating Tank Pressure does on save after input
--------------
Under the Dive Chart Tab
When you trace the cursor over the lines on the graph
- the correct time is not displayed - Every dive starts at 12:00 AM.
- the bar graph - print units and graph title is too small to read - What is this suppose to tell me?
________Note: You may or may not realize__________
I did not realize to change (right side panels) no deco time, depth and dive time and temp required clicking on the line.. This may have been obvious to everyone else.
Last edited: