I will be in Hollywood FL November 10-14 for a work convention and want to get out on the 11th. Any recommendations for a good boat close. Thought about Key Largo but don't want to drive that far because we have to be back by the afternoon.
Thanks
Kevin
Just purchased a D26 light and after first dive I noticed that the on/off button had come off. I tried contacting Xtar thru there website and thru manufacturers thread here with no reply. Just trying to find out if button can just be replaced or is the light junk.
Thanks
Kevin
I just purchased a D26 Whale and took it on its first dive. Afterwords I noticed that the on/off knob was missing. Can these be replaced or is the light junk at this point.
Thanks
Kevin
I will be in Jacksonville in early November for work and want to try and set up a two tank dive. Been looking online for boats but haven't really seen anything. Was wondering if anyone has good recommendations. Not looking to spear just dive.
Thanks
Kevin
Finally got around to bring a set of double lp72s to shop to get hydrod and vip. When I showed up they had passed hydro but they had put put them back together. When I was asked how I wanted the manifold set up I mentioned that I dove with a double hose and then there was the uhoh this tank has...
Had this given to me but not sure what it is. He thought it was a Mako but not sure. It had a gas engine but plan on converting to electric if it works.
Thanks
Kevin
Sent from my DROID RAZR using Tapatalk 2
Has anyone tried this type of holder for their tanks. Scuba Tank Cradle, Holder. Stops Tanks from Rolling | eBay Looking for something that I can have my backplate still attached to the tank when it is strapped in.
Thank
Kevin
I have SI TECH drysuit inflator valve that is leaking, it is labeled 21203. Does anyone know if there are rebuild kits for these or should I just replace it.
Thanks
Kevin
I was just given an old Mako compressor with out a motor. Not sure of the the specs yet originally it had a 3hp gas engine which is gone. Was wondering if I should just put another gas engine on or go electric, leaning towards gas that way it is more portable but would like to get some opinions...
Anyone know of a housing for a Fuji S4500. My wife just bought one and my old camera took a dump. Have not been able to find one online.
Thanks
Kevin
Sent from my DROID RAZR using Tapatalk 2
I posted a question about the protocol for the USCG approaching a boat flying the diver down and alpha flag. Got some replies on this site that were pretty friendly but the same question on a different boating forum got really nasty. I believe there must be a lot of maritime law experts or they...
Does anyone know, hopefully someone in the Coast Guard know what the current regulation for a USCG boat approaching a boat with a dive flag up and divers in the water. We where diving in the St Lawrence river this weekend and had 5 divers in the water and a USCG boat pulled up with engines...
Why is there are shutoff inline on this. The dive shop answer was in case it starts to free flow but the if you shut it off you have no inflator. The reason I am asking is we had a club dive this weekend with some new divers. One of them started having issues and I saw her headed for the...
I just purchased an older Achilles inflatable and pulled out the wooden floorboards to repair a small leak. And the genius that I am didn't pay attention when I removed them. At the transom there is a cleat attached and there is a cleat on the rear most floor board. How do these go together...
Was wondering if anyone else saw this. Sounds like there may be more from the one comment.
Erie Canal shipwreck found in Oswego River believed to date to between 1830 and 1850 | syracuse.com
Kevin
I already posted this in the general video section but this maybe a better place.
I just got this housing off ebay and was listed as a ikelite aluminum video housing. Was wondering about how old it is and maybe what camera it is for. It is too short for my Sony 8mm and I am probably just going...
I just got this housing off ebay and was listed as a ikelite aluminum video housing. Was wondering about how old it is and maybe what camera it is for. It is too short for my Sony 8mm and I am probably just going to get a newer digital.
Thanks
Kevin
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.