Search results

Pm sent

If this is to my board, I 100% agree!! It was a PITA to get everything aligned, but it went this way because it was built with a box of fittings I got for $50 bucks…….so I was constrained since I was trying to build with what I had laying around. I don’t feel bad since I built the whole manifold...

Double post

Idea 3 is to boost between HP banks. Not use it as drive gas. Idea 4 is to use it as drive gas as a convenience or to eliminate the upfront cost of buying a shop compressor. I also called it out as inefficient. OP never said they have a shop compressor already and it wasn't listed in their...

1 & 2 deleted.........read the in/out on haskell backwards. 3 - Get your haskell so it can boost from your banks(if your filtration is Oxygen compatible from the compressor) to the tanks and even bank to bank. 4 - setup a method to run the haskell from the 4500psi air bank as a secondary...

Orifice, bought the equipment from an old dive shop and the owner gave ma an orifice. It works good. https://www.mcmaster.com/products/orifice-fittings/maximum-pressure-temperature~4000-psi-70-f/

Just got mine, everything looks great on it. Fit it good! Suit was delivered in less than a month from submitting my measurements, so this worked of me since my other suit is MIA.

Dm sent.

Looks like Si Tech Item No: 13350WN might be what you are looking for if you don't mind DIY. The kit even comes with the right gasket(weld nut?)

Here's the inside nut. It's too small for apeks inflator or deflator. The OD on the male side is 2.27".

They won't work. The XCCR is a dry suit deflator port. I can easily blow into the counterlung and it starts dumping, here in my kitchen. I only used the XCCR lungs once underwater because they do not sit flat and flop around out the sides. If you want this dump type, get the Fathom brand as...

Anyone ever seen a valve like this? Looking for an inflator bottle on my rebreather with a special first stage.

The DiveXtras are very good for the price they are. Please just don't expect it to have the durability of a $7000 scooter. Most of the damage I have seen is from shipping or dropping them on the nose cone. They have proven reliable for the people I have sold them to in Mexico. I would suggest...

I always insist on going to the police department to pay. They usually drop it after I insist long enough that they take me to pay.

I never got the AP mouthpiece to seal well on the shrimp bov. I ended up cutting the mouthpiece portion off and zip tying it over a normal mouthpiece. Kind of like the Rebreather Day 1 brand.

Definitely is a reg. Hooked it up to a pressure gauge and has 130psi.

Anyone able to identify this regulator?

Double check the spacing on the manifolds you buy. Some of the 5.5in bands are non standard spacing and require a special manifold.

this is the one I think I have. I bought it because it is an AC to AC inverter which creates "clean" power no matter the input. I use it to feed all my electronics while in Mexico in case of low voltage or spikes.

DM sent