Search results

  1. T

    Service kit for this Beuchat Regulator 1st and 2nd stage

    Good afternoon regulator experts. My Beuchat regulator has been free flowing a bit. Due to IP creep (confirmed by an IP gage). It needs a service. It is super simple on the inside, just a spring, piston and seat. I have already taken it apart, cleaned all the salt and gunk out. It needs a new...
  2. T

    MCH 6 questions - Ratio of 13X and Carbon in Filter and Storing Compressor on an angle?

    Good afternoon wise folk of ScubaBoard. I have two questions surrounding filtration for my Coltri MCH6. I have the 13X and carbon to perform a filter re-pack. I initially was planning on using similar ratios to the existing filter (1 part carbon, 2 parts 13X). But looking at the...
  3. T

    More MCH 6 questions (quietening, filtering and time to fill)

    Good afternoon, A few more questions after getting my MCH-6 to run ok and pump a few tanks. Thanks for all the advice previously, has made me feel a lot better about using it properly. How to make MCH 6 less noisy? Thought of putting it on a rubber mat and putting rubber washers on either...
  4. T

    Coltri MCH 6 question/ advice appreciated

    Good morning scubaboard, Long time reader, first time poster. I have been doing a lot of learning about compressors thanks to this site. So, I have bought a Coltri MCH 6 Compressor electric powered (2.2kw, 14 amp, 220 volt, 50 hertz) motor which is about 20 years old and have been trying to...
Back
Top Bottom