Search results

Couv, Sorry for the delay in responding, yes I did find a replacement. Thanks again for your offer. Kelemvor, Thanks for the idea, now that I have a replacement I will try to clean up my original compass. If it works, it won't hurt to have a backup. Thanks Ruger

GJC, Thanks for the link, that does look like it may fit. I will have check into it. Thanks Ruger

Couv, Thanks for your best wishes, I have a feeling I will have a hard time finding one due to the shape and how it is held in. Thanks, Ruger

Couv, Thank you for the offer, but looking at your compass I don't think that it will fit in my console. It's hard to see in the picture that I took, but the base of my compass is wider than the opening in the console, which is what holds the compass in place. From the pictures you took the...

It looks like I included the incorrect measurements in my original post. the rotating bezel is approximately 1-5/8", the overall diameter is about 2", and the compass does not have any screws on the back. I looked closer and the rotating bezel is not what is hazy but it appears that the face of...

James, Yes your compass does look like the one I have. I will pull out the dremel and give it a shot I sure can't make it any worse than it already is. I will also check ebay. Oly, I will also check ikelite. Thanks for your replies. Ruger

I'm not sure that this qualifies as a piece of vintage equipment, but I'll ask it anyway. I have a 3 gauge Pennform Console and the compass that is in the end position was manufactured by Dacor. The rotating bezel diameter is approximately 2" in diameter and the thickest part on the ends is 7/8"...