Caveat, this is really a question for Bryan at VDH, but since he is otherwise disposed and many are here to talk shop because we can't get out into the water, I'll ask anyway.
So I have a new to me DA aqua master. When I apply air to it, it has a leak around the threads of the first stage. The main threads holding the nozzle into the body. I can see on the diagram that there is a gasket/oring under the first reg. I have a phoenix on order. And I assume that the gasket (part no 8210-03) would be a part of that kit, but we all know what assuming does. I wasn't sure if that gasket was considered part of the first or second stage. It already has the HPR in it.
Does anyone know if that gasket is part of the kit? And/or is there a place to source that gasket?
Email to Herman has also been sent regarding tool recommendations.
Thanks,
txgoose
So I have a new to me DA aqua master. When I apply air to it, it has a leak around the threads of the first stage. The main threads holding the nozzle into the body. I can see on the diagram that there is a gasket/oring under the first reg. I have a phoenix on order. And I assume that the gasket (part no 8210-03) would be a part of that kit, but we all know what assuming does. I wasn't sure if that gasket was considered part of the first or second stage. It already has the HPR in it.
Does anyone know if that gasket is part of the kit? And/or is there a place to source that gasket?
Email to Herman has also been sent regarding tool recommendations.
Thanks,
txgoose