wrybosome
Contributor
I'm replacing the neck seal on Bare ATR with a DUI latex seal. So far I've cleaned and prepped the surfaces, and attached the suit neck flat to a round piece of plywood.
Tonight I'll apply the contact cement and put the seal on. I'll be doing this freehand rather than buying any special placement jig.
So, if you have any words of wisdom regarding how you approach this I'd love to hear them. Dry runs show me that a small amount of stretching is going to be required.
Tonight I'll apply the contact cement and put the seal on. I'll be doing this freehand rather than buying any special placement jig.
So, if you have any words of wisdom regarding how you approach this I'd love to hear them. Dry runs show me that a small amount of stretching is going to be required.