• Welcome to ScubaBoard

  1. Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

    Benefits of registering include

    • Ability to post and comment on topics and discussions.
    • A Free photo gallery to share your dive photos with the world.
    • You can make this box go away

    Joining is quick and easy. Login or Register now by clicking on the button

Oceanic Prodigy Puck computer disassembly

Discussion in 'Vintage Diving & Equipment' started by tokashikibob, Jul 15, 2021.

  1. tokashikibob

    tokashikibob Registered

    # of Dives: 50 - 99
    Hello, I have 3 vintage pucks and would like to get to the lcd board to clean the contacts as the black digits are faded. the pucks look to have 2 orings to overcome to get the back off. Has anyone done this, does the back screw off?
    Best regards, Bob

    Attached Files:

  2. TheDMV

    TheDMV Registered

    # of Dives: 1,000 - 2,499
    Location: Australia
    I've just picked up an old Oceanic Veo 180NX which is passingly similar (puck, single button), which I need to open up to replace the broken button spring.

    Have you had any luck on dismantling yours?
  3. jadairiii

    jadairiii Solo Diver

    Only use the hammer on the workbench as a last resort.....
  4. couv

    couv Instructor, Scuba

    # of Dives: 1,000 - 2,499
    Location: 13th floor of the Ivory Tower
    Judging from these two pictures, I would say a strap wrench on the body and a pin spanner on the back ought to do it.
    IMG_1826.JPG IMG_1828.JPG

Share This Page