Petrel 2, sw v38, high pP02 on OC

[gorcio]

Hello,

after upgrading firwmware to v38, my Petrel 2 keeps flashing High PP02 warnings in red, every time I switch gas to deco. Last even was today, on a light deco dive, switching to O2 at 6m - flashing red, high PP02 warning, and request to confirm. Depth reading was ok (6.1 m), OC Deco set (after last events) to 1.64.
Flashing continued well in 4m range and only stopped at 4. Looks like it is taking 1.4 pP02 for whatever reason.
Does anybody know the explanation, reason, or procedure to get it fixed ?

Best regards

gorcio

 

[tbone1004]

in the settings you can tell hit what ppo2 you want to set as your limit. I can't remember what page it's on, but somewhere in there you can choose what your ppo2 limit is

 

[gorcio]

Never mind - noticed that there is v44 available - will try to upgrade to this one and check if it still keeps happening.

BR

gorcio

 

[gorcio]

in the settings you can tell hit what ppo2 you want to set as your limit. I can't remember what page it's on, but somewhere in there you can choose what your ppo2 limit is

That's exactly what I did if you read my post. There are three settings (in Advanced Configration) :
1. OC Min PPO2 - set to 0.16
2. OC Max PPO2 - set to 1.44
3. OC Deco PPO2 - set to 1.64

 

[tbone1004]

yeah, so you should be able to increase or decrease those settings in that menu