Hi,
I have a Puck Air PDC which I have managed to break the wiring off between the sensor at the end of the high pressure hose and the unit itself.
I've had it for a few years so it's not covered under warranty but I believe if I could find out which wires should be connect to where on the sensor I might be able to breathe some life back in to it.
There are four wires to connect, red, white, blue & black, and four pins in a straight line on the sensor.
Has anybody else had the same problem and managed to fix it or does anyone know who I might be able to contact at Mares to try and get hold of the wiring diagram? (I've had no luck trying to fing an email address for Mares technichal support)
Thanks,
Nick
I have a Puck Air PDC which I have managed to break the wiring off between the sensor at the end of the high pressure hose and the unit itself.
I've had it for a few years so it's not covered under warranty but I believe if I could find out which wires should be connect to where on the sensor I might be able to breathe some life back in to it.
There are four wires to connect, red, white, blue & black, and four pins in a straight line on the sensor.
Has anybody else had the same problem and managed to fix it or does anyone know who I might be able to contact at Mares to try and get hold of the wiring diagram? (I've had no luck trying to fing an email address for Mares technichal support)
Thanks,
Nick
