salth2owannabe
Contributor
I am going to replace my BC fill valve, do I need to put any sealant along the hose connection or once attached it will seal fine without it?
Thanks for the help.
Thanks for the help.
Replacing BC fill valve?
- Thread starter salth2owannabe
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
No sealant should be used. A little silicone grease to make it easier to install if you like but nothing else. I prefer to use 2 tie wraps instead of 1.
DevonDiver
N/A
Yeah, double tie-wrap it for security.
The only hard part is getting the hose to slide on.
The only hard part is getting the hose to slide on.
OP
salth2owannabe
Contributor
Appreciate the help!
Similar threads
