hornetplt
Guest
I have the VR3 ppO2 sensor attached via a P-port into my Azimuth and have been dealing with corrosion on one(and only one) of the female ends of marine connector(connects end of sensor cable to I/O port on computer)only after a few dives. There does not appear to be any water entering the o-ring sealed connector but find that the corrosion still accumulates. Associated with the corrosion(oxidation) are erroneous ppO2 readings......the only cause that I can think of is the fact that I leave the marine connector attched to the computer both in and out of the water. The connector has 2 plastic plugs that will seal each end of the connector if disconnected, maybe this is something I should be doing after diving. But isn't it a sealed system. Any help would be most appreciated! Thanks!