MichaelMc
Working toward Cenotes
From the Deep6 manual under troubleshooting, if the IP is low, you should adjust it up. But if it is high or creeping, you should replace the HP seat and rebuild. Does this imply that once initially set that the IP should only be adjusted further up, and not down?
I come to this question as, out of curiosity with compatibility with the low IP of a Poseidon XStream, I adjusted mine down to the 125 range and likely may have turned it out even lower. After returning it to 135 (on a lowish pressure tank) it then had unbounded creep if tank pressure was above about 1800. I was careful to purge or breath while adjusting and reinstalled the environmental cap while (lowish) pressurized. Nothing looks remiss after complete disassembly, short of a magnifying glass. I was curious if the likely cause is the large change to the IP or some error of mine in not purging during adjustment. It worked great prior to my little IP range experiment, .
Reassembly with the spare service parts kit is pending on a torque wrench decision. Thanks.
I come to this question as, out of curiosity with compatibility with the low IP of a Poseidon XStream, I adjusted mine down to the 125 range and likely may have turned it out even lower. After returning it to 135 (on a lowish pressure tank) it then had unbounded creep if tank pressure was above about 1800. I was careful to purge or breath while adjusting and reinstalled the environmental cap while (lowish) pressurized. Nothing looks remiss after complete disassembly, short of a magnifying glass. I was curious if the likely cause is the large change to the IP or some error of mine in not purging during adjustment. It worked great prior to my little IP range experiment, .
Reassembly with the spare service parts kit is pending on a torque wrench decision. Thanks.