Hello,
I have a Santi E.lite dry suit and have recently purchased the BZ400 heated under suit and a bulkhead connector. My question is regarding the install of the bulkhead connector on the Apeks valve, I am wondering how you run the suit side power cable through the valve? Do you drill a hole in the valves rear cover?
Or is there a different cover required for the Apeks valve when installing the bulkhead to heat a suit?
I contacted customer service at the factory with this question and have not received a reply to date.
Thanks,
I have a Santi E.lite dry suit and have recently purchased the BZ400 heated under suit and a bulkhead connector. My question is regarding the install of the bulkhead connector on the Apeks valve, I am wondering how you run the suit side power cable through the valve? Do you drill a hole in the valves rear cover?
Or is there a different cover required for the Apeks valve when installing the bulkhead to heat a suit?
I contacted customer service at the factory with this question and have not received a reply to date.
Thanks,