Fishyhead
Contributor
I bought a couple of Scubapro MK10 and G250s to take a part and learn how these things work then rebuild them and use.
Since I'm still waiting for tools and replacement parts, I decided to hook an IP gauge to one of the MK10s and observed the following:
After purging, the gauge stops at roughly 135 psi - sometimes just below, sometimes just above but most of the time at 135.
If I let it sit, the pressure seems to rise up a couple of psi in 15 minutes but hasn't gone past 138.
Is this considered IP drift or creep? I did the same test on my USD Conshelf and the pressure is a steady 140 (just serviced last year).
Since I'm still waiting for tools and replacement parts, I decided to hook an IP gauge to one of the MK10s and observed the following:
After purging, the gauge stops at roughly 135 psi - sometimes just below, sometimes just above but most of the time at 135.
If I let it sit, the pressure seems to rise up a couple of psi in 15 minutes but hasn't gone past 138.
Is this considered IP drift or creep? I did the same test on my USD Conshelf and the pressure is a steady 140 (just serviced last year).