Hi,
I have a problem with my MARES Puck Pro. Indeed, wanting to perform an update of the firmware, go to version 3.20 to 4.00, I first had a "time-out" in the software "Dive Organizer 2.18" and then I had a power failure in my computer during this update :fail:.
However, Puck Pro was spent on "boot".
After removing the battery for more than one day, when I put the battery, Puck Pro always rekindled with the inscription "boot".
If I plug in the USB adapter, the red LED stays on and if I try to run an update, I get an error message saying "Unsuccessful Computer programming, thank you again"
I do not know what to do and I said an incident on the portal.
I am very annoyed because I have to leave in a little over two weeks and completed a certification I need a dive computer must.
Would anyone give me a solution for this problem on the Puck Pro?
Thanking you in advance, for your responses and your help, I wish you a good weekend.
Best Regards,