As discussed previously here
Scubapro O-ring Sizes
my custom order of EPDM Duro 90 orings that might match the 01.050.317 in the new Mk19EVO has just arrived from Precision Associates Inc.
They are sized at 1.905mm C/S x 2.591mm ID.
Hooray!
The Min Order Quantity plus the custom run for an o-ring not in stock anywhere that I could find in the US set me back a couple hundred dollars.
They're available for anyone trying to create homemade Mk11/Mk17/Mk19EVO service kits using
Scubagaskets diaphragms
(SG10.117.107 205) or
(SG10.705.119 375)
and HP seats
(SG10117209 8500)
and o-rings from wherever you source your orings. This balance chamber o-ring was the one I couldn't find anywhere.
In the thread above, I had provisional orders from
@abeck70
@L13
These o-rings are available for anyone interested at $7 for 10 o-rings if you are in First Class Mail territory, or US$6.40 plus postage anywhere else. With a little luck, I'll recoup a bit of the cost of this experiment, lol!
DIY Forever!!
Scubapro O-ring Sizes
my custom order of EPDM Duro 90 orings that might match the 01.050.317 in the new Mk19EVO has just arrived from Precision Associates Inc.
They are sized at 1.905mm C/S x 2.591mm ID.
Hooray!
The Min Order Quantity plus the custom run for an o-ring not in stock anywhere that I could find in the US set me back a couple hundred dollars.
They're available for anyone trying to create homemade Mk11/Mk17/Mk19EVO service kits using
Scubagaskets diaphragms
(SG10.117.107 205) or
(SG10.705.119 375)
and HP seats
(SG10117209 8500)
and o-rings from wherever you source your orings. This balance chamber o-ring was the one I couldn't find anywhere.
In the thread above, I had provisional orders from
@abeck70
@L13
These o-rings are available for anyone interested at $7 for 10 o-rings if you are in First Class Mail territory, or US$6.40 plus postage anywhere else. With a little luck, I'll recoup a bit of the cost of this experiment, lol!
DIY Forever!!