I posted a 3D Printed Nauticam zoom gear for the Nikon Z-mount 24-50mm lens on Thingiverse. This lens is typically used with the WWL-C wet lens.
www.thingiverse.com
The gear works well, and it all fits very cleanly, turns easily. I used a PLA+ hard plastic for the gear and a TPU sleeve for the lens. Remove the rubber grip from the lens, and put the sleeve on in its place. It should slip on with a little effort and grips well. Place the rim down of the sleeve toward the camera. The gear slides over the sleeve, rim first with gear side away from the camera.
The 24-50 lens has a sort of "twist to lock" feature as the element telescopes out of the body when in use. The gear has enough grip to lock/unlock it, and then turns easily from 24-50 when in the housing.
Nikon 24-50Z Zoom Gear for Nauticam by AwkwardSwine
Nikon 24-50Z Zoom Gear for Nauticam Underwater Housing This lens is typically used in combo with the Nauticam WWL-C wet lens. The gear works well, and it all fits very cleanly, turns easily. I used a PLA+ hard plastic for the gear and a TPU sleeve for the lens. Remove the rubber grip from the...
www.thingiverse.com
The gear works well, and it all fits very cleanly, turns easily. I used a PLA+ hard plastic for the gear and a TPU sleeve for the lens. Remove the rubber grip from the lens, and put the sleeve on in its place. It should slip on with a little effort and grips well. Place the rim down of the sleeve toward the camera. The gear slides over the sleeve, rim first with gear side away from the camera.
The 24-50 lens has a sort of "twist to lock" feature as the element telescopes out of the body when in use. The gear has enough grip to lock/unlock it, and then turns easily from 24-50 when in the housing.
