Hi Folks.
I have a Nikon FP7100 in a Fantasea FP7100 housing to suit.
Yes it's quite an old setup but basically still works fine.
However there are small rubber or plastic caps on the inner ends of the housing control knobs that interface the relevant camera controls, allowing you to adjust settings.
These have all crumbled & fallen to pieces over time.
I've searched for replacements, including dozens of unanswered emails to Fantasea with absolutely no success.
I've also tried blobs of Blue Tac & silicon etc, once again with minimal success.
Has anyone had a similar problem, but more importantly, found a solution?
Thanks
Jim
I have a Nikon FP7100 in a Fantasea FP7100 housing to suit.
Yes it's quite an old setup but basically still works fine.
However there are small rubber or plastic caps on the inner ends of the housing control knobs that interface the relevant camera controls, allowing you to adjust settings.
These have all crumbled & fallen to pieces over time.
I've searched for replacements, including dozens of unanswered emails to Fantasea with absolutely no success.
I've also tried blobs of Blue Tac & silicon etc, once again with minimal success.
Has anyone had a similar problem, but more importantly, found a solution?
Thanks
Jim
