cdiver2
Contributor
I have a Sea & sea cx600 housing and the instructions say
SCREW ON DOME PORT FIRMLY THEN ENGAGE LOCKING PIN.
If I screw the dome port on hand tight the notch will not line up with the locking pin, if I back it up about a 1/4 turn the notch then lines up and I can engage the locking pin.
Doe's anyone know if this is correct.
SCREW ON DOME PORT FIRMLY THEN ENGAGE LOCKING PIN.
If I screw the dome port on hand tight the notch will not line up with the locking pin, if I back it up about a 1/4 turn the notch then lines up and I can engage the locking pin.
Doe's anyone know if this is correct.