happy-diver
Skindiver Just feelin it
- Messages
- 5,326
- Reaction score
- 4,790
- # of dives
- 2500 - 4999
Grind the face of the socket flat
Wanted scubapro yoke nut socket
- Thread starter rsfinn57
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
JoeTPhilly
Contributor
If converting one time it is probably cost effective to just buy the DIN conversion from a shop and let them do the conversion. If you are going back and fourth for travel or may need for other regs I would buy the correct socket. Below is a link to the one I purchased. The shipping is a killer though.
1" Yoke Nut Socket
Yoke Nut Sockets At Scuba Tools, we manufacture two custom yoke nut sockets and a custom 3/8" drive extension. These tools allow the technician to accurately torque yoke nuts on most first stages.The sockets are available in two sizes: 1 inch and 26 mm. Both sockets are manufactured...
www.scubatools.com
happy-diver
Skindiver Just feelin it
- Messages
- 5,326
- Reaction score
- 4,790
- # of dives
- 2500 - 4999
I use a big shifter
and hold it ten degrees up from the job in a vice
and hold it ten degrees up from the job in a vice
OP
rsfinn57
Contributor
have the kit decided to let shop do it as i need a new second stage serviced. will use yoke Adapter if need thanx all
One yoke first stage, one DIN first stage. Easy peasy...
And then the gear hoarding begins....
And then the gear hoarding begins....
OP
rsfinn57
Contributor
I already have a severe gear fetish
Similar threads
