Because I got rolled in the sand in Monterey AGAIN, I recently had to learn how to disassemble SiTech drysuit inflater and exhaust valves. I couldn't find any information on the exhaust valve on line -- the few posts I found said not to try it, because the plastic was too fragile and would break. Since I couldn't fix the valve any other way, I decided to go for it, and it proved surprisingly easy to do.
Because I couldn't find anything on this on line, I made a little photo essay to help anybody else who decides to tackle this. Rather than crosspost the whole thing, HERE's the link.
Total tools: One screwdriver. Time to disassemble, clean and reassemble -- less than ten minutes.
Hope this will help anybody else who finds themselves in my position.
Because I couldn't find anything on this on line, I made a little photo essay to help anybody else who decides to tackle this. Rather than crosspost the whole thing, HERE's the link.
Total tools: One screwdriver. Time to disassemble, clean and reassemble -- less than ten minutes.
Hope this will help anybody else who finds themselves in my position.