Hiya,
One of the pull cords (there are two) for the OPV release valves on my Zena got caught in the bench of a boat, and pulled off. Looking closer at it after unscrewing the OPV valve, the cord snapped at the entry point to the round thingey inside the valve. I pulled the rubber backing off of this round plastic peace that the cord threads through.
To fix this, can I just thread the pull cord through the hole, knot it to hold, then glue the rubber backing back onto it? Or do I need to replace the whole pull cord assembly?
Thanks!,
J
One of the pull cords (there are two) for the OPV release valves on my Zena got caught in the bench of a boat, and pulled off. Looking closer at it after unscrewing the OPV valve, the cord snapped at the entry point to the round thingey inside the valve. I pulled the rubber backing off of this round plastic peace that the cord threads through.
To fix this, can I just thread the pull cord through the hole, knot it to hold, then glue the rubber backing back onto it? Or do I need to replace the whole pull cord assembly?
Thanks!,
J