- Messages
- 17,291
- Reaction score
- 9,489
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
As above and photos below.
I can list it all out but a picture speaks a thousand words. All spares are new.
There is a face plate removal tool, not really needed but I wanted it anyway. There is one original cover but it is kinda scratched up, wasn't on either of these regs.
There are 2 service kits but they do not have poppets in them as not required for service and I wanted them.
I'll list spares:
1x main diaphragm
1x lever
4x micro adjusters
4x re useable mouth piece clips
2x flow switches
2x flow vanes
6x R195 face plates
4x friction washers (for R195 covers)
1x adjustment knob end cap
2x purge buttons
2x purge button decals
2x service kit (no poppets)
1x face plate removal tool
1x used and ugly original face plate.
These have been used 10-15 times I think. If you swap your new face plates provided, cosmetically 8.5/10. Perfectly functioning and not in need of service.
If someone buys them they'll notice upon arrival One has blue rubber bands covering openings, this one is tuned to 1-1.1" and was primary, the other tuned to 1.2" and was my back up. I replaced jam nut O rings.
They were properly rinsed and taken care of post dive.
I'd like ¥55,000 the lot (around $500 USD) plus shipping. Shipping standard air likely ¥2000-2500, maybe a fraction less.
Please message me if interested.
Thank you.
I can list it all out but a picture speaks a thousand words. All spares are new.
There is a face plate removal tool, not really needed but I wanted it anyway. There is one original cover but it is kinda scratched up, wasn't on either of these regs.
There are 2 service kits but they do not have poppets in them as not required for service and I wanted them.
I'll list spares:
1x main diaphragm
1x lever
4x micro adjusters
4x re useable mouth piece clips
2x flow switches
2x flow vanes
6x R195 face plates
4x friction washers (for R195 covers)
1x adjustment knob end cap
2x purge buttons
2x purge button decals
2x service kit (no poppets)
1x face plate removal tool
1x used and ugly original face plate.
These have been used 10-15 times I think. If you swap your new face plates provided, cosmetically 8.5/10. Perfectly functioning and not in need of service.
If someone buys them they'll notice upon arrival One has blue rubber bands covering openings, this one is tuned to 1-1.1" and was primary, the other tuned to 1.2" and was my back up. I replaced jam nut O rings.
They were properly rinsed and taken care of post dive.
I'd like ¥55,000 the lot (around $500 USD) plus shipping. Shipping standard air likely ¥2000-2500, maybe a fraction less.
Please message me if interested.
Thank you.