I'd like to know why my Sherwood Amphos only displays depth and temperature while on a dive.
This is my first open water dive with this computer and I logged 15 dives in total during this trip. Each dive displayed the same thing.
Before my first dive:
I was practicing settings for Nitrox during my enriched air training to configure the FO2 levels. I had also changed my PO2 value to 1.40 as per the enriched air manual suggestion.
I reset both GAS1 and GAS2 to 21% Oxygen before my first dive and set Default 50% to off. As far as I can tell that is all I had altered and didn't notice the AIR setting when I made the resets. The manual says they will be treated the same way as AIR if set to 21% anyways.
I didn't dive with enriched air on any of my dives. I only dove with 1 tank at a time and didn't know how to deactivate GAS2 unless that is to indicate Nitrogen which isn't obvious anywhere. Now that I am writing this should GAS 2 be set to 79% if GAS 1 is set to 21%?
During the dive:
It activated when I hit the water as expected though as I went deeper it only displayed Depth and temperature. Time was not displayed nor anything else. I relied on my secondary computer for this. I continued my trip without making any changes to the computer to avoid risking any profile conflicts.
My log data seems to have logged all that info so it seems I missed something during my configurations?
Thanks in advance,
Alaktu
This is my first open water dive with this computer and I logged 15 dives in total during this trip. Each dive displayed the same thing.
Before my first dive:
I was practicing settings for Nitrox during my enriched air training to configure the FO2 levels. I had also changed my PO2 value to 1.40 as per the enriched air manual suggestion.
I reset both GAS1 and GAS2 to 21% Oxygen before my first dive and set Default 50% to off. As far as I can tell that is all I had altered and didn't notice the AIR setting when I made the resets. The manual says they will be treated the same way as AIR if set to 21% anyways.
I didn't dive with enriched air on any of my dives. I only dove with 1 tank at a time and didn't know how to deactivate GAS2 unless that is to indicate Nitrogen which isn't obvious anywhere. Now that I am writing this should GAS 2 be set to 79% if GAS 1 is set to 21%?
During the dive:
It activated when I hit the water as expected though as I went deeper it only displayed Depth and temperature. Time was not displayed nor anything else. I relied on my secondary computer for this. I continued my trip without making any changes to the computer to avoid risking any profile conflicts.
My log data seems to have logged all that info so it seems I missed something during my configurations?
Thanks in advance,
Alaktu