crab
Contributor
To anyone who has assembled this unit using the panel meter with surface mounted resistors... I am having a really fun time trying to connect the leads from the pot to the nearly microscopic contacts where I removed the R3 resistor from the board. I understand that older models of the meter had a larger top mount resistor that could be snipped off-- I wish I had one of those, it sounds much easier to solder to the leads to.
I am open to any tips/suggestions. I will be emailing Oxycheq with the question as well, but I don't expect to get a reply until next week.
Thanks!
I am open to any tips/suggestions. I will be emailing Oxycheq with the question as well, but I don't expect to get a reply until next week.
Thanks!