scrane
Contributor
I just hooked up the Conshelf SEA first stage I rebuilt agout 6 months ago. Today, much to my amazement, the second stage I attached started free flowing like crazy (thank goodness). I had checked out the first stage right after I rebuilt it and it was fine. I dismantled the reg from the diaphragm side and noticed the pin was not centered in the pin support bore. UhOh. I flipped the reg over and dismantled the HP side and found this:
It looks like the seat from the rebuild kit was defective under load, but I just wanted to check if I might have done something wrong on assembly. Has anyone seen anything like this before?
Anyways, back together under pressure to check for creep/ possible crown damage.
It looks like the seat from the rebuild kit was defective under load, but I just wanted to check if I might have done something wrong on assembly. Has anyone seen anything like this before?
Anyways, back together under pressure to check for creep/ possible crown damage.