I have a Panasonic TZ7/ZS3 in a panasonic oem housing. I just got a S&S YS-01 strobe and was working on adapting the fiber optic cable to the housing. I know Inon makes a $30 cap for this but I figured I could use the generic velcro end and just plaster it on the housing. The housing doesn't have a flat surface anywhere to put the velcro so I mounted it to the diffuser.
Here's the question....... Does anyone know what the strobe "reads" to adjust DS-TTl? My problem is that the TTL doesn't seem to work through the diffuser, but does work (no changes in camera settings) when I hold the cable directly over the flash. Should it work through the diffuser? Did I do something in the mounting to block it or does the diffuser mask the signal needed for TTL?
Here's the question....... Does anyone know what the strobe "reads" to adjust DS-TTl? My problem is that the TTL doesn't seem to work through the diffuser, but does work (no changes in camera settings) when I hold the cable directly over the flash. Should it work through the diffuser? Did I do something in the mounting to block it or does the diffuser mask the signal needed for TTL?