TampaDiver68
Registered
After diving today, I was cleaning my Nauticam housing as usual- removed the camera/tray, put a soft weight in it to hold it down in a tub if water, pulled a vacuum, let it soak for a bit, and worked all the buttons. After soaking a bit more, the light turned yellow, but no alarm. I removed from water, dumped vacuum, and opened it up. There were some drops in the bottom, which I cleaned out with a few Q tips. When I turned sensor system off then on, I got a blue light flash, followed by a very quick blue flash, then a click from the speaker. This repeated. So I replaced the battery, and now I get a blue light which then turns to red, and the alarm goes off. With the back of the housing in hand, just turning it on causes the alarm, and it is dry.
Any ideas on how to reset this?
Any ideas on how to reset this?