porbeagle
Contributor
I have just started to service my own regs and I have a question for the usual suspects.
I am under the impression that 1st stage IP is checked initially with a full tank (3000psi).
I have lots of old 72s but no al80s.Will the roughly 700psi difference affect how I should
set IP? If factory spec. should be,let's say,between 125psi and 145psi must I compensate
When I set IP because I use a lower pressure tank ? How does this work?
Thanks in advance
PORBEAGLE
I am under the impression that 1st stage IP is checked initially with a full tank (3000psi).
I have lots of old 72s but no al80s.Will the roughly 700psi difference affect how I should
set IP? If factory spec. should be,let's say,between 125psi and 145psi must I compensate
When I set IP because I use a lower pressure tank ? How does this work?
Thanks in advance
PORBEAGLE