MultiDeco Problem

[Divetech99]

Hi,

Using MultiDeco IOS app on an iPhone, I'm trying to do a deco dive plan. 45 meters, 30 minutes, Air + 50% + 100%. Last stop 6 meters.

The calculated plan will not include 100% O2 at 6 meters deco stop. Yes, 100% is included in the Deco Mix along with 50%. Is this a bug? What should I do to have 100% included in the plan to accelerate my deco at 6 meters?

I tried looking for the support email on the MultiDeco support site. Couldn't find it . Is MultiDeco being supported?
.

 

[rhwestfall]

seems to function fine for me on android. Running version 2.15..
there is a link in the software in the "about" menu to contact them.

It is: support@multideco.com

or PM Ross Hemmingway, rossh is his member name here on the board.....

 

[Jax]

The calculated plan will not include 100% O2 at 6 meters deco stop. Yes, 100% is included in the Deco Mix along with 50%. Is this a bug? What should I do to have 100% included in the plan to accelerate my deco at 6 meters?
.

Is the block checked on the 100? Sometimes a misclick . .. .

Is the 50% and 100% in the Deco mix side?

What is the depth you chose for the depth change? Did you set it, or did you leave it at auto?


I may have found it. I set the 100% to 30 ft (~10m) and it did not start until 20 ft (~6.2m). Check the depth setting for the 100%, just in case. Still, the 100% WAS included . . . Check your settings.

 

[Jax]

PS - using MultiDeco for Android.

 

[rivers]

works fine on my iphone. But why 2 deco gases for that bottom time? Using 30/85 GF, it cuts about 9 minutes off of the deco schedule.

 

[KenGordon]

It might make his lost gas scenarios better.

Op, there is a slider for the max depth for 100% explicitly.