PST HP120 Iso. Manifold

[longbeachdiver]

I have a pair of PST HP 120's and I am looking for an Isolation Manifold that would fit the tanks. Everything I have seen so far is for tanks with 3/4-14 inlet. And according to PST, these tanks have 7/8-16 inlet. Does anyone know where I could find a manifold that would fit.

 

[LUBOLD8431]

OMS might have a few left that they had. Check with Northeast Scuba Supply (http://www.northeastscubasupply.com/). They had some a little while ago...

The problem is, the manufacturers that were producing these manifolds stopped making them shortly after PST stopped making the HP cylinders with the 7/8 neck.
So, you need to find a shop somewhere with these in stock...

 

[longbeachdiver]

Thanks for the heads up. I sent John at north east scuba supply an email asking about those. I was hoping they were the right ones.

Thanks Again

 

[LUBOLD8431]

Yup, they are. he got the last bunch of them...

 

[roakey]

You can also try Diver's Supply:

http://www.divers-supply.com/

They no longer list the 7/8, 300 BAR manifold, but they might still have a few in stock. I'd call them directly.

Roak

 

[GDI]

Genesis Makes valves with iso for that thread pattern. You may not like the 45 degree angle on the valve though

 

[nyresq]

ebay!!!!!!
you see them up for sale every now and then.