cariss2709
Registered
So I've got an Apeks ATX200 that I've been using. It just occurred to me that I should know more about what the lever thingy and the knob doo-dad does.
When would you want to keep the venturi lever in the +/- position? I know + means possible freeflow and - eliminates it. But when would you want to adjust the lever?
Also, the resistance control knob. I know it controls the breathing resistance, but when would you adjust it? I'm guessing when its completely out it might possibly breathe a bit wet with possibly freeflow? And when its in you'll have a tougher time breathing? So probably cold water you might want to loosen it and tighten with warm water. Or maybe its just diver preference. Of course, I might just be completely making this up...
Anyways, hope this is the right spot to post it. Thanks!
When would you want to keep the venturi lever in the +/- position? I know + means possible freeflow and - eliminates it. But when would you want to adjust the lever?
Also, the resistance control knob. I know it controls the breathing resistance, but when would you adjust it? I'm guessing when its completely out it might possibly breathe a bit wet with possibly freeflow? And when its in you'll have a tougher time breathing? So probably cold water you might want to loosen it and tighten with warm water. Or maybe its just diver preference. Of course, I might just be completely making this up...
Anyways, hope this is the right spot to post it. Thanks!