OP
Purge
Contributor
Today I finally had the fortitude to see it through... it is done!
All it took was 1 patch, 3 spiced rums, and 1 hammer blow.
Now I just need to figure out which gaskets to use.
The Halcyon pee valve didn't come with any so I made two pairs, one set from compressed 1/16" neoprene material and one set from silicon sheet.
I'm wondering if I should use a two or not, I think I've seen a thread where someone said to only use one on the inside?
All it took was 1 patch, 3 spiced rums, and 1 hammer blow.
Now I just need to figure out which gaskets to use.
The Halcyon pee valve didn't come with any so I made two pairs, one set from compressed 1/16" neoprene material and one set from silicon sheet.
I'm wondering if I should use a two or not, I think I've seen a thread where someone said to only use one on the inside?
