I am trying to get 5 off - 300 BAR DIN converter kits for oceanic CDX-5. I have checked the regulator end thread and it appears to be about 0.620" diameter and 24 TPI.
I have been asking about and it appears a difficult one to resolve. I did however find that my Mk 11 Scubapro DIN fitting is also 24 TPI and screws in just fine. The pictures are of the K valve fitting currently on the regulators. Is the Scubapro Mk 11 kit a generic kit and thus would fit my CDX-5 as well? If not can anyone recommend a kit to use? I posted this elsewhere but it was an old 2009 post so probably the wrong place to post.
I have been asking about and it appears a difficult one to resolve. I did however find that my Mk 11 Scubapro DIN fitting is also 24 TPI and screws in just fine. The pictures are of the K valve fitting currently on the regulators. Is the Scubapro Mk 11 kit a generic kit and thus would fit my CDX-5 as well? If not can anyone recommend a kit to use? I posted this elsewhere but it was an old 2009 post so probably the wrong place to post.