Cyclon Second Stage Woes - Continuous Flow Problem!

[Njord fr]

Hey everyone!

I have a little issue with one of my Cyclon 5000's second stages.
When I press the purge button a bit too much, it goes into continuous flow, which is quite annoying, especially when I need to inflate my DSMB, for example...
I think it might be due to the excessive travel of the lever pin, but I haven't been able to figure out how to adjust it...

Just to be clear, this is not a problem of freezing, just adujstment !

Any ideas ?

 

[bletso]

Look into the mouthpiece and you will see a plastic barrel. Rotate it a bit test and do it until it doesn't go into free flow. (just use a pen or screw drive to push it over) It is just part of servicing the unt.

 

[Njord fr]

Look into the mouthpiece and you will see a plastic barrel. Rotate it a bit test and do it until it doesn't go into free flow. (just use a pen or screw drive to push it over) It is just part of servicing the unt.

My god, what a pleasure … thanks mate